How to Polish Metal Components

Although many metal corners are made out of stylish material that stands out, the intensity of the glossing coating will lose it’s appeal slowly over time. In order to keep all of your metal pieces vibrant and glossy, you must implement proper procedures to buff and polish the surfaces after they’re affected by different environmental elements.

The General Polishing Process

Buffing and polishing can be done without using special equipment; however, you’ll get quicker results if motorized tools are used throughout a lengthy project. If you’re going to tackle a project by using compounds and wheels, careful steps must be taken to make the metal glossy. Generally, if you know how to use sanding paper, you’ll have no problems operating special gadgets that buff and polish metal. The only difference is that buffing and polishing wheels operate at a faster pace, which is a big benefit because less elbow grease is required to produce professional results.

The goal while using professional-grade tools is to enhance the rough areas so that they’re smooth. Metal usually appears less glossy when the surfaces have a variety of jagged elements, which can be seen with a microscope. Strategic buffing and polishing can eliminate these flaws that affect a metal visual appeal.

Key Strategies

In some cases, other steps must be taken to eliminate flaws that can affect the appearance of metal before and after polish procedures have been implemented. Minor dents that are found on a metal piece should be repaired before any polishing tools are used. To prep a surface for repair, carefully sand the spot with emery paper. After sanding is complete, tap the dent gently with a hammer. If the metal has any swirls that won’t go away, you can eliminate them with a damp rag. After the material dries, apply a layer of powder to keep the metal swirl-free.

Metal componments can lose their appeal if they aren’t constructed out of highly efficient, commercial-grade material. However, you can keep your metal supplies in mint condition by buffing and polishing them with proper equipment that’s designed for metal products.

Comments are closed.